NEC C551Q User Manual page 46

Mail Setting
Click on "MAIL" on the left column below HOME.
This option notifies your computer about an error message via e-mail when using wired LAN. An error message will be sent
when an error occurs in the monitor.
ALERT MAIL
STATUS MESSAGE
SENDER'S ADDRESS
SMTP SERVER
RECIPIENT'S
ADDRESS 1 TO 3
AUTHENTICATION
METHOD
POP3 SERVER
USER NAME
PASSWORD
TEST MAIL
NOTE:
• If you execute a test, you may not receive an Alert email.
Should this happen, check whether the network settings are correct.
• If you entered an incorrect address in a test, you may not receive an Alert email.
Should this happen, check that the Recipient's Address is correct.
HINT: For the control command diagram, please see the file "External_Control.pdf" on the CD-ROM supplied with this
monitor.
Alert error message list
Error number
Alert mail Message
* ErrorCode
The monitor's power supply is not
70h ~ 7Fh
functioning normally.
The monitor's backlight unit is not
90h ~ 9Fh
functioning normally.
A0h ~ AFh The monitor is overheated.
A2h
The monitor does not receive an input
B0h ~ BFh
signal.
The battery for clocks is empty.
D1h
E0h ~ EFh A system error occurred in the monitor.
Selecting [ENABLE] will turn on the Alert Mail feature.
Selecting [DISABLE] will turn off the Alert Mail feature.
Selecting [ENABLE] will turn on the STATUS MESSAGE feature.
Selecting [DISABLE] will turn off the STATUS MESSAGE feature.
Type in the sender's address. Up to 60 alphanumeric and symbols characters can be used.
Type in the SMTP server name to be connected with the monitor.
Up to 60 alphanumeric characters can be used.
Type in your recipient's address. Up to 60 alphanumeric and symbols characters can be used.
This selects the authentication method of the email transmission.
This specifies the address of the POP3 server that is used in the authentication of the email.
This sets the user name for logging into the authentication server when authentication is required
for the email transmission. Up to 60 alphanumeric characters can be used.
This sets the password for logging into the authentication server when authentication is required for
the email transmission. Up to 60 alphanumeric characters can be used.
Click this button to send a test email to check if your settings are correct.
Explanation
Standby power abnormal
Backlight abnormal
Temperature abnormal
A Sensor reached the temperature limit
which was specified in the OSD.
No signal
The battery is empty.
System error.
English-44
Measure
Please contact your supplier.
Please contact your supplier.
Please contact your supplier.
Please contact your supplier.
Please check "No picture" in
"Troubleshooting".
Please connect the monitor to the
power then recharge the battery.
Please set (DATE & TIME) in OSD.
Please contact your supplier.