Table of Contents
Advertisement
Installation instructions
1. The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
2. This appliance has been designed
to operate in ambient temperatures
up to 38 degrees C (100 degrees F)
and is equipped with Freezer Guard
technology which ensures that even
if the ambient temperature falls to
-15 degrees C, frozen food in the
freezer does not thaw thanks to this.
So, you may then install your appliance
without having to worry about frozen
food in the freezer being spoilt.
3. Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance to
work harder. If installed next to a
source of heat or freezer, maintain the
following minimum side clearances:
From Cookers
From Radiators 300 mm (12")
From Freezers
4. Refer to "Maintenance and
cleaning" section to prepare your
appliance for use.
5. A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, on the side of the
compressor (see diagram). Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case of
transportation, ensure you locate the
plug in the receptacle provided to
avoid transit damage.
50 mm (2")
25 mm (1")
8
6. Attach 2 plastic wedges as illustrated
below. Plastic wedges are intended to
keep the distance which will ensure the
air circulation between your appliance
and the wall. (The picture is drawn up
as a representation and it is not identical
with your product).
7. The appliance should be
located on a smooth surface. The two
front feet can be adjusted as required.
To ensure that, your appliance is
standing upright adjust the two front
feet by turning clockwise or anti-
clockwise, until the product is in firm
contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
EN
Advertisement
Table of Contents
