Table of Contents
Advertisement
C
ALIBRATING THE
Calibrate the scanner if colors appear in areas that should be white, or colors of the
scanned image and the original vary a lot. This allows you to adjust and compensate
for variations that can occur in the optical component over time by its nature.
The following describes how to calibrate the scanner:
1. The Calibration Sheet, marked with an arrow on either edge at both sides, is
used specially for ADF Scanning calibration.
2. Insert the special calibration sheet into the ADF of the scanner, with an arrow
toward the scanner buttons.
Attention
3. Click Finder > Applications > Plustek > Your scanner model name >
Calibration_Wizard.
4. Click on the Start button to begin the calibration process.
5. The scanner pulls the calibration sheet through the scanner, which completes
this scanner calibration. After the calibration is complete, click OK.
S
CANNER
Please insert the special calibration sheet
included with the scanner. Alternatively you
may also use any plain white sheet of paper
sized in Letter/A4 instead; however, the
calibration effect may be less good than the
special calibration sheet.
Save the Calibration Sheet in case you need to
calibrate the scanner in the future.
27
Advertisement
Table of Contents
