Bevel Cutting - Makita XPS02 Instruction Manual

Bevel cutting

Loosen the clamping screws. Set for the desired angle by
tilting accordingly, then tighten the clamping screws securely.
► 1. Clamping screw 2. Bevel scale plate
1
► 1. Sub base (Optional accessory) 2. Clamping screw
Positive stopper
The positive stopper is useful for setting the designated angle
quickly. Turn the positive stopper so that the arrow on it points
22.5°. Loosen the clamping screws in front and back. Then tilt the
blade until it stops and secure the base with the clamping screws.
► 1. Positive stopper 2. Clamping screw
1
2
1
48°-bevel cutting
To perform 48°-bevel cutting, loosen the clamping
screws and fully tilt the lever toward the direction of the
arrow in the figure. Then set the bevel angle to 48° and
tighten the clamping screws.
1
► 1. Lever
-1°-bevel cutting
2
To perform -1°-bevel cutting, loosen the clamping
screws and press the levers toward the direction of the
arrow in the figure. Then set the bevel angle to -1° and
tighten the clamping screws.
2
► 1. Lever
Sighting
2
► 1. Base
The cutting line varies depending on the cutting angle
and whether you use the guide rail (optional accessory).
10 ENGLISH
1
A B
1
1