Makita DHS900 Instruction Manual page 13

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
► 1 . Hex wrench
Installing sub base
Install the sub base and tighten the clamping screws
securely as shown in the figure.
Always use the tool with the sub base unless when
using the guide rail.
1
► 1 . Clamping screw 2. Sub base
Removing or installing circular saw
blade
CAUTION:
installed with teeth pointing up at the front of the
tool.
CAUTION:
install or remove the circular saw blade.
To remove the circular saw blade, press the shaft lock
fully so that the circular saw blade cannot revolve and
use the hex wrench to loosen the hex bolt. Then remove
the hex bolt, outer flange, circular saw blade and ring
(country specific).
1
► 1 . Shaft lock 2. Hex wrench 3. Loosen 4. Tighten
For tool without the ring
1
2
► 1 . Hex bolt 2. Outer flange 3. Circular saw blade
4. Inner flange
13 ENGLISH
Be sure the circular saw blade is
Use only the Makita wrench to
3
1
2
4
1
2
3
4