Makita MAKSTAR BTL060RF Technical Information page 6

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Hammer Section (cont.)
DISASSEMBLING
5) Attach 1R045 and 1R346 to Hammer, and pull Hammer towards 1R346 as illustrated to left in Fig. 10.
Then remove Steel ball 4.8 (2 pcs) from Spindle using screwdriver magnetized with 1R288.
Hammer section can now be disassembled as illustrated to right in Fig. 10.
Note: When detaching 1R045 and 1R346 from Hammer, be sure to turn over Hammer section to put Hammer on the
bottom side. Otherwise, Steel ball 3.5 (22 pcs) in Hammer will scatter around.
Fig. 10
screwdriver magnetized
with 1R288
Steel ball 4.8
(2 pcs)
1R045
1R346
ASSEMBLING
Do the reverse of the disassembling steps
Note 1: As illustrated to right in Fig. 11, the groove inside Hammer is designed to have a space equivalent to
one half of a Steel ball 3.5 when twenty-two Steel balls are correctly installed.
Fig. 11
Steel ball 3.5
(22 pcs)
Hammer
Note 2: Flat washer 15 is not reversible
when assembled to Anvil.
The center hole of Flat washer 15
is beveled on on face, and plain
on the other.
Be sure to place the beveled face
on the T-end of Anvil. (Fig. 12)
Hammer
Ball bearing 6000
Spindle complete
Hammer
Steel ball 3.5
(22 pcs)
Fig. 12
beveled
T-end of Anvil Flat washer 15
Spindle complete
Ball bearing 6000
Washer 10
Compression spring 22
Flat washer 20
Steel ball 3.5 (22 pcs)
Hammer
space equivalent to
one half of a Steel ball 3.5
[Cross section]
beveled
T-end of Anvil Flat washer 15
P 6/ 9