Panasonic DMP-BD84GN Operating Instructions Manual page 27

Network
∫ Easy Network Setting (
∫ Network Settings
Perform network-related settings individually.
Press [OK] to show the following settings:
[BDT280]
LAN Connection Mode
Select the LAN connection method.
≥
[For_the_United_Kingdom_and_Ireland]
wireless LAN (when turning it off), select
"Wired".
[BDT280]
Wireless Settings
This allows the wireless router and connection
settings to be set up. Current connection
settings and connection state can be checked.
Press [OK] to show the following settings:
Connection Setting
The wireless router connection wizard will be
displayed.
Double Speed Mode Setting (2.4GHz)
Set the connection speed for a 2.4 GHz
wireless format.
≥ If you connect using the "Double Speed
Mode (40MHz)", 2 channels use the same
frequency band, and there is consequently
a greater risk of reception interference. This
can cause the connection speed to drop or
become unstable.
IP Address / DNS Settings
This is for checking the state of the network
connection and setting the IP address and
DNS-related.
Press [OK] to show the respective setting.
Proxy Server Settings
This is for checking the state of connection with
the Proxy server and performing settings.
Press [OK] to show the respective setting.
Settings
14)
When not using
- 27 -
Network Service Settings (
Press [OK] to show the following settings:
Time Zone
Set the unit's time to match your location.
≥ Some Network Service contents require the
time zone to be set. Set time zone if
necessary.
Summer Time
Select "On" when using summer time.
[BDT280] [BDT180]
[Except_South_East_Asia_and_HongKong]
Network Drive Connection
This unit can access a hard disk shared folder
on a network and play back videos, still
pictures, and music.
For the setting and operation method of
connected equipment, refer to the following
website.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
Remote Device Settings (
Press [OK] to show the following settings:
Remote Device Operation
Enable to start Network Service on this unit
by using another device such as Smartphone,
etc.
Enable to operate the unit by
[BDT280] [BDT180]
DMC.
Device Name Entry
Set the name of this unit to be displayed on
the connected equipment.
[BDT280] [BDT180]
Registration Type
Allow connections to all the
Automatic equipment accessing this
unit.
Set the permission for
individual equipment
Manual
connections accessing this
unit.
[BDT280] [BDT180]
Remote Device List
Registering/deregistering of the displayed
equipment can be performed when "Manual"
in "Registration Type" is selected.
19)
19, 21)