Advertisement
Step 1
Place the floor on a firm and level base,
ensure the base has suitable drainage free
from areas where standing water can collect.
See the front page for base requirments.
Step 2
Fix the corners with 50mm screws
as shown in diagram.
Do not secure the building to the
floor until the roof is fitted. Fix the
panels onto the floor using 50mm
screws in alignment with the floor
joists
Position the panels so there is equal spacing
between the floor and cladding on all 4 sides
3x50mm Screws
Pre drill
hole
50mm
screw
3
Step 3
Fix the corners with 50mm
screws as shown in diagram.
9x50mm Screws
Pre drill
hole
50mm
screw
Step 4
Place the ridge bar in between the front
and back gables. Ensure the top corners
of the ridge bar sit flush with the top
points of the door gable. Fix the ridge bar
to the gable using one L bracket for each
end.
Fix with 4x20mm screws each
8x20mm Screws
20mm
screw
Pre drill
hole
4
3
Use
for no
window buildings
P 8
Advertisement
