Download Print this page

Waltons 01PTCOR0707-V1 General Instructions Manual

7x7 pressure treated corner shed

Advertisement

Quick Links

BEFORE YOU START PLEASE READ INSTRUCTIONS CAREFULLY
TIMBER
BUILDING A BASE
TYPES OF BASE
Whilst all products manufactured are made to the highest standards of Safety and in the case of
childrens products independently tested to EN71 level, we cannot accept responsibility for your safety
whilst erecting or using this product.
Refer to the instructions pages for you speci c product code
x2
MUST
2mm Drill bit
Pressure Treated Timber
Quaternary ACQ Copper Azole CA
Micronized Copper Quaternary MCQ
Safety:
For assistance please contact customer care on: 01636 880514
Mercia Garden Products Limited,
Sutton On Trent,
Newark,
Nottinghamshire,
NG23 6QN
www.merciagardenproducts.co.uk
CAUTION
Alkaline Copper

Advertisement

loading

Summary of Contents for Waltons 01PTCOR0707-V1

  • Page 1 BEFORE YOU START PLEASE READ INSTRUCTIONS CAREFULLY CAUTION MUST 2mm Drill bit TIMBER Pressure Treated Timber Alkaline Copper Quaternary ACQ Copper Azole CA Micronized Copper Quaternary MCQ Safety: BUILDING A BASE TYPES OF BASE For assistance please contact customer care on: 01636 880514 Mercia Garden Products Limited, Sutton On Trent, Newark,...
  • Page 2 Nail Bag 30mm Screw x90 30mm Black Screw x3 80mm Screw x7 20mm Screw x6 50mm Screw x40 Felt Tacks x80 40mm Screw x40 Before assembly please make sure you have a suitable base ready to erect your building Pre Assembly MADE IN GREAT BRITAIN Floor Door Panel...
  • Page 3 Step 4 Step 2 3x50mm Screws The window and plain panels can be placed either side of the building. 50mm Pre drill screw hole 6x50mm Screws 50mm Pre drill screw hole Step 5 Step 3 Ensure to screw through the framing.
  • Page 4 Step 6 Step 8 6x50mm Screws 5x20mm Screws 1x30mm Black Screw 50mm Pre drill screw 20mm 30mm hole Pre drill screw screw hole Step 9 Step 7 4x80mm Screws Ensure the doors open freely and can be locked with the turn buttons 80mm Pre drill screw...
  • Page 5 Step 12 Step 10 Ensure the roof support bar is level with the top of the building. *It is recommended to cut the felt sheets using the roof as a template before xing into place. 21x40mm Screws 40mm Pre drill screw hole 2x80mm Screws...
  • Page 6 Step 14 Step 15 12x30mm screws 30mm Pre drill screw hole 80x Felt Tacks Felt tacks Step 16 6x30mm screws 30mm Pre drill screw hole HANDLE WITH CARE...
  • Page 7 Step 17 17x40mm screws 40mm Pre drill screw hole It is ESSENTIAL that you apply wood treatment immediately after the building has been assembled.