Table of Contents
Advertisement
DANGER:
Laser radiation. Avoid direct eye contact with light source.
WARNING:
Use of controls or adjustments or performance of pro-
cedures other than those specified herein can result in
hazardous radiation exposure.
TO ADJUST THE LASER GUIDE
See Figure 34.
Use the work clamp or a C-clamp to secure a piece of
scrap wood.
Plug the saw into the power source and make a slight
cut to score the wood.
Release the switch trigger and allow the saw blade to
stop rotating before raising the blade.
Raise the saw arm.
Unplug the saw.
Turn the laser switch on.
Using the Phillips end of the supplied blade wrench, turn
the laser adjustment screw counterclockwise to move the
laser line left or clockwise to move the laser line right.
NOTE: When properly aligned, the laser should be on the
left edge of the kerf.
Holding the laser assembly, tighten the laser adjustment
screw.
ADJUSTMENTS
LASER
ASSEMBLY
28 — English
LASER
ADJUSTMENT
SCREW
Fig. 34
Advertisement
Table of Contents
