Advertisement
Available languages
Available languages
When...
■The remote control is missing or a malfunction has occurred
1 .Raise the front panel.
2. Press AUTO OFF/ON once to use in AUTO mode.
3. Press AUTO OFF/ON until you hear 1 beep, then release to use in
4. Press AUTO OFF/ON again to turn off the unit.
■The indicators are too bright
• To dim or restore the indicators' brightness on the unit, press
seconds.
■ Conducting a seasonal inspection after extended period of non-use
• Check the batteries.
• Check that there is no obstruction around the air inlets and outlet vents.
• Use AUTO OFF/ON on the unit to select COOL mode. For details, refer "The remote control
is missing or a malfunction has occurred" above. After 15 minutes of operation, it is normal
to have the following temperature difference between the air inlet and outlet vents:
COOL: ≥ 8 °C / 14.4 °F
■ The units will be not used for an extended period
• Activate nanoe
-G operation for 2~3 hours as an alternative to remove moisture left in the
TM
internal parts thoroughly to prevent mould growth.
• Turn off the power supply and unplug the unit.
• Remove the batteries from the remote control.
NON SERVICEABLE CRITERIAS
TURN OFF THE POWER SUPPLY AND UNPLUG THE UNIT. Then consult an authorised
dealer in the following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote control.
• Water is leaking from the indoor unit.
• The circuit breaker switches off frequently.
• The power cord becomes unnaturally warm.
• The switches or buttons are not functioning properly.
forced COOL mode.
on the remote for 5
35
Advertisement
