Waterpik Technologies WaterFlosser WP-120 Quick Start Manual

1
Prepare the Reservoir:
Remove the reservoir from
Fill
base and fill with lukewarm
water.
Replace the reservoir onto
PRESSING DOWN
the base,
FIRMLY to ensure full seating.
3
Prime Unit (First Time Use Only):
Prior to Very First Use of Unit, Prime Unit:
Set pressure control dial on base to high, point
the handle and tip into sink. Turn unit
water flows from the handle, turn unit OFF.
High
This device is compatible with global voltages of 100–240VAC, 50/60Hz.
QUICK START GUIDE
Replace
ON
until
2
Select and Insert Tip:
Insert
4
Adjust Pressure and Pause Control:
For first time
users, adjust
pressure control
lowest position.
to
Gradually increase
pressure as you prefer.
Low
Model WP-120
NO
Gap
Press tip firmly into
handle. When tip is
properly inserted there
should be no gap
between handle and
colored tip ring.
You can temporarily stop
water flow by pressing
the pause button on
the handle.
PAUSE
continued on back