Table of Contents
Advertisement
30
ASSEMBLING AND PREPARING / MAKING CONNECTIONS
Tidying cables
Image shown may differ from your TV.
Gather and bind the cables with the cable holder.
Cable holder
CAUTION
y Do not move the TV by holding the cable holder,
as the cable holder may break, and injuries and
damage to the TV may occur.
MAKING CONNECTIONS
This section on MAKING CONNECTIONS mainly uses
diagrams for the EG9609 models.
Connect various external devices to the TV and switch
input modes to select an external device. For more infor-
mation on external device's connection, refer to the manual
provided with each device.
Available external devices are: HD receivers, DVD players,
VCRs, audio systems, USB storage devices, PC, gaming
devices, and other external devices.
NOTE
y The external device connection may differ from the
model.
y Connect external devices to the TV regardless of the
order of the TV port.
y If you record a TV program on a DVD recorder or
VCR, make sure to connect the TV signal input
cable to the TV through a DVD recorder or VCR. For
more information of recording, refer to the manual
provided with the connected device.
y Refer to the external equipment's manual for
operating instructions.
y If you connect a gaming device to the TV, use the
cable supplied with the gaming device.
y In PC mode, there may be noise associated with the
resolution, vertical pattern, contrast or brightness.
If noise is present, change the PC output to another
resolution, change the refresh rate to another rate or
adjust the brightness and contrast on the PICTURE
menu until the picture is clear.
y In PC mode, some resolution settings may not work
properly depending on the graphics card.
y If ULTRA HD content is played via PC, the video
or audio may have disruptions intermittently
depending on your PC's performance. (Depending
on model)
Advertisement
Table of Contents
