Maintenance - DeWalt DCF620CM2 Instruction Manual

4. Contact work surface, applying forward pressure to drive screw
until depth locator contacts the work surface. Screwgun will
ratchet automatically, disengaging bit from screw.
5. This depth sensitive screwgun is suitable for driving drywall
screws.
FOR THIS DEPTH SENSITIVE CLUTCH PLEASE REMEMBER:
• The bit will not turn until pressure is applied to the unit. Push to
engage.
• Trigger switch will not depress unless tool is in either forward or
reverse position.

MAINTENANCE

WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not
use water or any cleaning solutions.
NOSECONE MAINTENANCE (FIG. 1, 5)
If the nose cone (D) becomes hard to turn it may be contaminated
with drywall dust.
1. Remove nose cone from tool.
2. Rinse thoroughly with warm water while rotating both screw
depth adjustment collar (B) and locking collar (C). Never use oil or
solvents.
3. Dry the nosecone completely before reattaching to tool.
Accessories
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D WALT recommended accessories should be used with
E
this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact D
Industrial Tool Co., 701 East Joppa Road, Towson, MD 21286,
call 1-800-4-D WALT (1-800-433-9258) or visit our website: www.
E
dewalt.com.
Repairs
The charger and battery pack are not serviceable.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by a D WALT factory service center, a D
E
authorized service center or other qualified service personnel. Always
use identical replacement parts.
13
WALT
E
WALT
E