Raid Configuration - MSI P6NGM Series Manual

RAID Configuration

Basic Configuration Instructions
The following are the basic steps for configuring NVRAID:
Non-Bootable RAID Array
1. Choose the hard disks that are to be RAID enabled in the system BIOS. (To enable
the SATA 0/ 1/ 2 Primary/ Secondary Channel in nVidia RAID Setup of Inte-
grated Peripherals in BIOS.)
2. Specify the RAID level, either Mirroring (RAID 1), Striping (RAID 0), Striping and
Mirroring (RAID 0+1), RAID 5 or JBOD and create the desired RAID array.
3. Enter the W indows OS, run the W indows nForce Setup application and install the
RAID software. (Check p.C-9 for details.)
4. Initialize the NVRAID Array Disks.
Bootable RAID Array
1. Choose the hard disks that are to be RAID enabled in the system BIOS. (To enable
the SATA 0/ 1/ 2 Primary/ Secondary Channel in nVidia RAID Setup of Inte-
grated Peripherals in BIOS.)
2. Specify the RAID level, either Mirroring (RAID 1), Striping (RAID 0), Striping and
Mirroring (RAID 0+1), RAID 5 or JBOD and create the desired RAID array.
3. Boot from the W indows CD, use the floppy disk that has the RAID driver to copy
and install the nForce RAID software. (Check p.B-7 for details.)
4. Initialize the NVRAID Array Disks.
Setting Up the NVRAID BIOS
Be sure to enable the RAID function in SATA Channel of Integrated Peripherals
in BIOS before configuring the NVRAID BIOS. After that press F10 to save the con-
figuration and exit. The PC will reboot right away. Then enter the RAID BIOS Setup by
pressing F10 when prompted, and follow the procedures described below to set up
the NVRAID BIOS.
NVRAID BIOS setup lets you choose the RAID array type and which hard drives you
want to make part of the array.
Entering the RAID BIOS Setup
1. After rebooting your PC, wait until
you see the RAID software prompt-
ing you to pres s F10. T he RAID
prompt appears as part of the sys-
tem POST and boot process prior to
loading the OS.
2. Press F10, and the NVIDIA RAID Util-
ity --- Define a New Array win-
dow will appear.
The default RAID M ode is set to
M irroring and Striping Block is
set to Optimal.
nVidia RAID
B-3