Bartec Auto ID TECH300 User Manual page 11

T e c h 3 0 0
Copy/Clone Set Used to Copy/Clone a winter tyre set with the same ID´s as the summer
tyre set. Requires the reading of the old sensor to program the same ID on
the replacement sensor to avoid the relearning process.
Create ID Used to create a single sensor with a new ID. Can be repeated as many
times as requested. The ID needs to be relearned to the vehicle's ECU. The
following pages will describe this procedure.
Copy/Clone ID Used to Copy/Clone a single ID. Can be repeated as many times as
requested. Requires the reading of the old sensor to program the same ID
on the replacement sensor to avoid the relearning process.
Enter ID Manually Used to create a Sensor with a new ID that can be typed in manually. This
option only appears for some sensors. If it is not possible to copy the ID,
enter the same ID manually, which is written on the sensors body.
Copy Using Gives you the option of using stored IDs either read from the TPMS sensors
or from the vehicle OBD
stored data
The current coverage list is available at
The user has the option to either create or copy the ID.
Notice: Sensors need to be read before copying.
Sensors that can be programmed by the tool may have slightly different procedures and times.
Recommended sensor position for programming:
User Guide R.59.1
www.bartecautoid.com
11 | P a g e
2 0 2 0