Advertisement
ADJUSTING THE GUIDE BAR
There are three adjustment slots in the guide bar.
With the bar in the t-slot of your saw, insert the hex
key (provided) into the set screw at the center of
the slot. Adjusting this screw up and down will
expand and contract the width of the bar. Adjust
each slot so that you eliminate lateral play but
still have smooth sliding action across the entire
fence.
SETTING ANGLES
To set commonly used angles, position the fence in the vicinity
of the desired angle. Compress the detent plunger on the
underside of the outer brace until it seats in the hole, now
tighten the angle clamp knob
To manually set an angle, first loosen the angle clamp knob.
Move the fence forward or back until the desired angle is
indicated at the edge of the red outer brace (red pointer) then
lock the clamp knob securely.
LATERAL POSITIONING
You can position your fence closer or farther away from the
Fence Clamp Knobs
blade (maintain at least 1/8" for safety).
Simply loosen the two fence clamp knobs, slide the fence to the
desired position, then lock securely.
Never attempt to adjust the fence while the saw is running.
EXTENSION STOP
The fence extension can telescope out of the
main fence by loosening the extension clamp
knob and sliding it out to the desired distance,
secure the flip stop to the extension for
repeatable long cuts.
6
Advertisement
