Boss KATANA-100/212 Mk II Owner's Manual page 5

8
TONE SETTING
Here you can store or recall sounds that you've set up on the panel.
On the KATANA-50 Mk II, you can store a total of four sounds. On the
KATANA-100 Mk II, KATANA-100/212 Mk II, and KATANA-HEAD Mk II,
you can store a total of eight sounds.
KATANA-50 Mk II
BANK A CH1, CH2
BANK B CH1, CH2
KATANA-100 Mk II, KATANA-100/212 Mk II, KATANA-HEAD Mk II
BANK A
CH1, CH2, CH3, CH4
BANK B
CH1, CH2, CH3, CH4
MEMO
To switch between BANK A and BANK B on the KATANA-50 Mk II,
KATANA-100 Mk II, or KATANA-100/212 Mk II, or KATANA-HEAD Mk II,
hold down the [PANEL] button for approximately one second when
any one of the [CH1]–[CH4] buttons are selected.
The selected [CH1]–[CH4] button blinks, and the bank switches
between BANK A and BANK B. When BANK B is selected, the [PANEL]
button blinks slowly.
* You can't switch banks while PANEL is selected.
[CH 1]–[CH 4] buttons
The [CH 1]–[CH 4] buttons (CH 1–CH 2 on the KATANA-50 Mk II)
remember the settings of all top panel knobs (except for the
[MASTER] knob) and buttons. When you press and hold a button for
one second, the panel settings are stored.
* You can make the settings back to the factory state by turning the
power on while holding down the [PANEL] button.
[PANEL] button
Makes the unit sound using the current settings of the panel knobs.
9
[CAB RESONANCE] switch
Adds the resonance of a connected speaker cabinet.
Value Explanation
VINTAGE The warm and sweet sound of a vintage cabinet.
MODERN A modern cabinet sound notable for a tight low-end.
DEEP Sound with powerful low-end as well as a distinctive edge.
10
[POWER] switch
Turns the power of the KATANA Mk II on/off.
100/212, HEAD only
Panel Descriptions
5