Table of Contents
Advertisement
Anvil/Blade Clearance:
It is recommended that the clearance between the rotor and anvil be set and maintained at 1/32 to 1/16 inch to obtain the best
performance. Use the stationary blade mounting bolts to set the clearance as required.
Twig Breaker:
Caution: Clear the area of bystanders, especially small children.
Stop the engine, remove the ignition key and place it in your pocket and wait for all moving parts to stop before unplugging.
Pull the material out of the feed hopper. Be sure all the material is out and nothing is jammed or wedged between the input
opening and the rotor.
Pull the material out of the discharge hood. Use a stick to poke loose any material jammed into the discharge hood. Do not
allow anything to remain in this area.
12
Advertisement
Table of Contents
