Table of Contents
Advertisement
en operation
13.8 Changing the activated
"Ready in" time
If you have set and activated a
"Ready in" time for a delayed pro-
gramme start, you can change the
"Ready in" time again before the pro-
gramme starts.
Requirements
¡ The programme is set.
→ "Setting a programme", Page 28
¡ The "Ready in" time is set and ac-
tivated.
→ "Buttons", Page 22
Press Start / Reload.
1.
The activated "Ready in" time is
paused.
Press Finish in repeatedly until the
2.
display indicates the desired
"Ready in" time.
Press Start / Reload.
3.
The changed "Ready in" time is ac-
tivated.
13.9 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start / Re-
load.
To resume the programme, after
3.
the desired soaking time, press
Start / Reload.
13.10 Adding laundry
Press Start / Reload.
1.
The appliance pauses.
appears, it is not pos-
Note: If
sible to add laundry.
When
goes out, it is possible to
add laundry.
30
Open the appliance door.
2.
Add or remove laundry.
3.
Close the appliance door.
4.
Press Start / Reload.
5.
13.11 Cancelling the pro-
gramme
Press Start / Reload.
1.
Open the appliance door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→ "Programmes", Page 23
Remove the laundry → Page 30.
3.
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
→ "Buttons", Page 22
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
Set the Spin programme or a pro-
1.
gramme for draining the water.
→ "Programmes", Page 23
Press Start / Reload.
2.
13.13 Unloading the laundry
Open the appliance door.
1.
Remove the laundry.
2.
Advertisement
Table of Contents
