Table of Contents
Advertisement
DA1500 USA 1langue:pdf print
DESCRIPTION
1.
Voltage selector
(120/240 V)
2.
Temperature control
3.
Steam switch
4.
Microsteam 200 soleplate
BEFORE IRONING
Remove the sticker on the soleplate
or the protector soleplate
Adjust the voltage selector.
• Adjust the iron to correct voltage for
your location, using a sharp object.
If the voltage selected is 120 V, the iron
will operate at 100 to 120 V.
If it is set at 240 V, the iron will operate
at 200 to 240 V.
Note!
If necessary, check that you are using an adapter which meets the
safety requirements of the country you are in.
Put the handle into the ironing position.
• Press the release button on the`
rear side and raise the handle
until it locks into position.
• For storing press release button
again to close the handle.
STEAM IRONING
Filling the water tank
Note !
Your iron has been designed to operate using untreated tap water.
Important: Heat concentrates the elements contained in water during
evaporation. The types of water listed below may contain organic waste,
or chemical elements that can cause spitting, brown staining, or premature
wear of the appliance :
*Depending on the model: these accessories are specific to certain models or available as an option.
22/09/08
9:54
5.
High precision tip
6.
Folding handle
7.
Water filling inlet
8.
Burst of steam button
9.
Handle release
.
*
OK
4
Page 4
Advertisement
Table of Contents
