Bosch SGE53U56UC/C9 Operating Instructions Manual page 18

Setting the Amount of Rinse Aid
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
To change the setting:
1
Press the [On/Off] button.
2
Hold down the "A" button (see page 15) and press [Start] until the display indicates "H:0x"
(x can be any number).
3
Release both buttons.
4
Press the "A" button until the display shows "r:05".
5
Press the "C" button to select the desired setting.
"r:00" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
"r:04" = medium/high setting
"r:05" = high setting
"r:06" = highest setting
6
Press [Start] to save the setting.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Press the [On/Off] button.
2
Press the [+] button until the display jumps to "h:01".
3
Press the [+] or [-] button until the displayed time corresponds with your requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
4
Press [Start] to activate delay start.
To cancel delay start:
1
Press the [+] or [-] button until "h:00" is indicated on the digital display.
2
Press and hold [Start] for 3 seconds to cancel the cycle. You may now start a new cycle.
NOTE: Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than 4 sec-
onds after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button again and close the
appliance door.
16