Jet 505921 Operations & Parts Manual page 4

25. Give your work undivided attention. Looking
around, carrying on a conversation and
"horse-play" are careless acts that can result
in serious injury.
26. Do not force a tool or attachment to do a job
for which it was not designed. The right tool
will do the job better and more safely.
27. Repetitive motions
constant vibration can be harmful to hands
and arms. Take frequent breaks and relax
hands during extended operation. Change
posture to avoid discomfort or fatigue.
28. Compressed air can be harmful if directed
toward sensitive areas of the body, and may
propel small particles caught in the air stream.
Exercise proper caution.
29. Use only recommended
improper accessories may be hazardous.
30. Maintain tools with care. Keep air tool clean
and oiled for best and safest performance.
31. Do not use combustible gases, carbon
dioxide, oxygen or any bottled gas as an air
source for the tool. These can present risk of
explosion and serious injury.
32. Do not lubricate the tool with combustible
liquids, such as kerosene, diesel or jet fuel.
33. Do not dispose of this tool with normal
household waste. Never dispose of the air tool
into fire.
Specific warnings for Riveters
34. This tool is designed for inserting blind rivets
into metal surfaces up to 3/16-inch thick. If you
are not familiar with the proper and safe
operation of a pneumatic riveter, do not use
until proper training and knowledge have been
obtained.
35. Do not operate riveter without safety cap
installed, as mandrel may be expelled from
the tool forcefully causing injury.
36. Do not install rivets close to the edge of a work
surface, as it may cause workpiece to split,
causing a safety hazard.
37. Make sure tool is cleared of spent mandrel
before inserting new rivet into nosepiece.
4 JAT-920 Pneumatic Riveter
and/or exposure
accessories;
38. This tool is for inserting rivets into metal
surfaces – do not use on soft surfaces.
WARNING: This product can expose you
to chemicals including lead which is known to
the State of California to cause cancer and
birth defects or other reproductive harm.
For more information go to http://www.
to
p65warnings.ca.gov.
WARNING: Some dust, fumes and gases
created by power sanding, sawing, grinding,
drilling, welding
activities contain chemicals known to the State
of California to cause cancer and birth defects
or other reproductive harm. Some examples of
these chemicals are:
 lead from lead based paint
 crystalline silica from bricks, cement and
other masonry products
 arsenic and chromium from chemically
treated lumber
Your risk of exposure varies, depending on
how often you do this type of work. To reduce
your exposure to these chemicals, work in a
well-ventilated area and work with approved
safety equipment, such as dust masks that are
specifically designed to filter out microscopic
particles.
http://www.p65warnings.ca.gov/
www.p65warnings.ca.gov/wood.
Familiarize yourself with the following safety
notices used in this manual:
are not heeded, it may result in serious, or even
fatal, injury.
are not heeded, it may result in minor injury
and/or possible tool damage.
and other
For more information
This means that if precautions
This means that if precautions
construction
go to
and http://