Balt LX-72B Assembly Instructions Manual page 5

Note:
Camlocks can be turned with Allen Wrench, or Large Phillips Screwdriver
4.
Place the Left Side Panel (P-1) with the Predrilled
holes facing up and install 2 Cam Posts (D) in the 2
threaded insert nuts (Pre-installed) as shown
in illustration # 2.
5.
Install 2 Cam Locks (C) in the 2 large holes.
6. Install 8 Wood Dowels (E) into
the holes as shown in illustration # 2.
P-2
E
Illustration # 3
P-4
E1
Illustration # 4
10.
Place the Divider Panel (P-4) with the Pre-drilled holes facing up and
install 2 Cam Locks (C) in the 2 large holes as shown in illustration # 4.
11.
Slide 6 Wood Dowels (E1) Through 4 holes until they protrude the same
on both sides.
12. Attach 2 Magnets (K) using 4 Screws (A7) as shown in illustration # 4.
C
D
C
A7
E1
K
A7
E
C
E
7.
8. Install 2 each Cam Locks (C) in the 2 large holes.
Install 8 Wood Dowels (E) into the holes as shown in
9.
illustration # 3.
K
5
E
Place the Right Side Panel (P-2)
with the Predrilled holes facing up
and install 2 each Cam Posts (D) in
the 2 threaded insert nuts (Pre-
installed) as shown in illustration # 3.
Be sure that arrow on
top of Camlock (C)
aligns with centerline of
Edge Drilled hole.
P-1
Centerline of
Edge Drilled
hole.
Illustration # 2
D
P-1
Phillips
Screwdriver
Arrow