Table of Contents
Advertisement
UsInG THE PRoJECToR
setup remote settings menu
IR function
Set the IR function setting.
‡
on: Choose "On", the projector can be operated by the remote control from the top and front IR
receivers.
‡
off: Choose "Off", the projector can't be operated by the remote control. By selecting "Off", you will be
able to use the Keypad keys.
Remote Code
Set the remote custom code by pressing the remote ID button for 3 seconds and you will notice the remote
indicator (above the Off button) starts blinking. Then, input a number between 00-99 using the keyboard numbered
keys. After inserting the number, the remote indicator blinks twice quickly indicating that the remote code has
changed.
f1/f2/f3
Assign the default function for F1, F2, or F3 between Test Pattern, Brightness, Contrast, Sleep Timer, Color
Matching, Color Temp, Gamma, Projection, or MHL.
setup projector ID menu
Projector ID
ID definition can be set up by menu (range 0-99), and allow user control an individual projector by using RS232 command.
setup 12V trigger menu
12V Trigger
Use this function to enable or disable the trigger.
‡
off: Choose "Off" to disable the trigger.
‡
on: Choose "On" to enable the trigger.
setup HDbaseT control menu
Ethernet / Rs232
The projector can automatically detect the Ethernet or RS232 signal from the HDBaseT transmitter supplied. For an
automatic detection, make sure the respective signal is enabled.
HDbaseT mode
Select the HDBaseT mode.
‡
auto: The projector will automatically detect the signal from HDBaseT transmitter supplied.
‡
HDbaseT: The projector will activate Direct Power mode.
note:
When HDBaseT control is "ON", 12V trigger output signal will always be "ON", even if the projector is on
Standby mode.
Reserved
IR_IN & detect
GND
43
English
Advertisement
Table of Contents
