FMI Vantage Hearth BG18NT Owner's Operation And Installation Manual page 17

BG & BGE Series Burner System - Log Compatibility Chart
Burner System Models
BG18NT, BG18PT,
BGE18NT, BGE18PT
BG2436NT, BG2436PT,
BGE2436NT, BGE2436PT
FIBER LOG MODELS
LBG(18,24,30,36)-SM
Note: Your appliance may vary from model
shown but log placement will be the same.
1. Place bottom log in center of the base as-
sembly as shown in Figure 18.
2. Rest rear log in back corner sections of
base assembly as shown in Figure 18.
Make sure log is completely vertical and
not leaning in toward burner where flame
will touch the log.
3. Position front right log against right side
of grate prongs (see Figure 18).
4. Position front left log against left side of
grate prongs (see Figure 18).
Front Left
Log
Grate
Prongs
Bottom Log
Base Assembly
Figure 18 - Installing Log Set
125526-01B
INSTALLATION
Continued
FIBER LOG
MODELS
LBG18-SM
LBG24-SM,
LBG30-SM,
LBG36-SM
5. Place middle right log over front right and
bottom logs as shown in Figure 19. Be
sure hole in middle right log seats over
pin in bottom log.
6. Place middle left log over front left and
bottom logs as show in Figure 19. Be
sure hole in middle left log seats over pin
in front left log.
Middle
Left Log
Rear Log
Pin on Front
Left Log
Front
Right Log
www.fmiproducts.com
CONCRETE LOG
MODELS
LBG18-RM
LBG24-RM,
LBG30-RM
Figure 19 - Installing Log Sets
Middle Right Log
Bottom
Log
17