Technical Data - Zanussi ZITN646K User Manual

Problem
comes on.
and a number come on.
You can hear a constant beep
noise.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error

9. TECHNICAL DATA

9.1 Rating plate
Model ZITN646K
Typ 60 GAP D5 AU
Induction 3.0 kW
Ser.Nr. .................
ZANUSSI
9.2 Cooking zones specification
Cooking zone Nominal power
(maximum heat
setting) [W]
Left front 2300
Left rear 1200
Right front 1200
Right rear 1800
Possible cause
There is no cookware on the zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
There is an error in the hob.
The electrical connection is incor‐
rect.
message that comes on. Make sure, you
operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee
are in the guarantee booklet.
PNC 949 492 459 00
220 - 240 V 50 - 60 Hz
Made in Romania
3.0 kW
PowerBoost [W]
2800
-
1800
-
Remedy
Put cookware on the zone.
Use suitable cookware. Refer to "Hints
and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
Disconnect the hob from the electrical
supply. Ask a qualified electrician to
check the installation.
PowerBoost Cookware diame‐
maximum dura‐ ter [mm]
tion [min]
10 180 - 210
- 125 - 145
4 125 - 145
- 145 - 180
comes
ENGLISH 13