Preparation Of Chassis - Goldstar WG6007R Owner's Manual

Preparation of Chassis

1. Insert the guide panels into the guides
of the air conditioner. Fasten the
curtains to the unit with screws
(Type A).
: Use a long screwdriver and
Tip!
installing the screws will be easier.
2. Cut the adhesive-backed seal strip
(Type D) to the window width.
Remove the backing from the seal
strip and attach the seal strip to the
underside of the bottom window.
3. Locating unit in window
Open the window and mark center line
on the center of the inner sill.
4. Attach L bracket
4-1. Install the L brackets behind the
inner window sill, with short side of
bracket as shown. Use the 2 screws
(Type A) provided.
4-2. The bracket helps to hold unit
securely in place. Be sure to place
bracket edge flush against back of
inner sill.
Type A
Seal Strip
(Type D)
Inner Sill
Inner Sill
Type A
Outer Sill
8"
8"
Outside
L Bracket
Owner's Manual 13
Installation
Type A
Inside
Center Line