LG WD-E1210RD Owner's Manual page 11

I nstallation
Level adjustment
Adjustable feet
Adjustable feet Adjustable feet
Concrete floors(tile...)
• The installation surface must be clean, dry and level.
• Install washer on a flat hard floor.
• Before placing the washer on tiles, apply a rubber mat under the feet.
※ Do not let the feet of the washer get wet. If feet of the washer get wet, slipping may occur.
Wooden floors
• Wooden floors are particularly susceptible to vibration.
• To prevent vibration we recommend you place rubber cups under each foot,
at least 15mm thick under the washer, secured to at least 2 floor beams with screws.
• If possible install the washer in one of the corners of the room, where the floor is more stable.
※ ※ Insert the rubber cups to reduce vibration.
※ ※ You can obtain the rubber cups (p/no.4620ER3001B) from the LG spares dept.
Important!
• Proper placement and levelling of the washer ensure long,regular and reliable operation.
• The washer must be absolutely horizontal and stand firmly in position.
• It must not "Seesaw" across corners under load.
• The installation surface must be clean, free from floor wax and other lubricant coatings.
1. Adjusting the washing machine level properly prevents excessive
noise and vibration.
Install the appliance on a solid and level floor surface, preferably in a
corner of the room.
Timber or suspended type flooring may contribute to
NOTE
excessive vibration and unblance errors.
2. If the floor is uneven, adjust the adjustable feet as required. (do not
insert pieces of wood etc. under the feet)
Lock nut
Make sure that all four feet are stable and resting on the floor and
then check that the appliance is perfectly level. (use a spirit level)
※ ※ After the washer is level, tighten the lock nuts up towards of the base of
the washer. All lock nuts must be tightened.
❊ Diagonal Check
When pushing down the edges of the washing machine top plate
diagonally, the machine should not move up and down at all. (Please,
check both of two directions)
If machine rocks when pushing the machine top plate diagonally, adjust
the feet again.
Rubber Cup
11