Advertisement
Quick Links
ASSEMBLY AND INSTALLATION
T0251
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Read and save these instructions.
Important to Know
1. Read all instructions carefully before installation and
operation.
2. If you are not familiar with state and local electrical
codes, it is recommended that you consult with a
qualified electrician.
3. Before installation, shut off power at the main fuse or
circuit breaker box. Be aware that simply turning off
the wall switch is not sufficient to prevent an electrical
shock.
4. This fixture requires a 120 VAC, 60 Hz power source.
Maximum wattage light bulb is 60W.
5. Do not attempt to take the lantern apart; there are
no serviceable parts inside.
6. To avoid sensor damage by lightning or electrical
surge, make sure the grounding wire is securely
connected.
7. For general safety and to avoid any possible damage
to the sensor, be sure the power is switched "off"
before replacing the bulb.
Maximum Wattage: 60W
Work Temperature: -4
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
0
0
F ~ 104
F
Back Plate
Headless Screws
Fixture Wire
Wire Nut
Back Plate
Rubber Pad
Ball Nut
Frame
Glass Shade
Metal Ring
Max.60W Type A
standard base bulb
(Bulb not included)
Set Screw
Features
1.Energy saving fixture.
2.Use the dim-to-bright illumination option where
you want some minimum illumination through out
the night, such as at your front entrance or garage
door. Use the dark-to-bright illumination option
where you do not need minimum brightness, such
as the backyard or back porch.
3.When in manual override mode, use wall switch
to keep the light on till dawn.
Hardware Package (included)
Mounting Plate
X1
Mounting Screw
X2
Mounting plate
Green Grounding Screw
Fixture Grounding Wire
Page 1 / 4
Headless Screw
Wire Nut
X2
X3
Lock Nut
Ball Nut
X2
X4
Lock Nuts
House Grounding Wire
Outlet Box
Fig.1
Rubber Pad
X2
Green Grounding
Screw
160831
Advertisement
Related Manuals for Quoizel T0251
Summary of Contents for Quoizel T0251
- Page 1 ASSEMBLY AND INSTALLATION INSTRUCTIONS T0251 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Read and save these instructions.
- Page 2 Installation Steps 1. Shut off power at the circuit breaker of where the fixture is to be installed. 2. Thread two headless screws through the mounting plate, then secure them with four lock nuts (two on each side of the cross bar). Adjust the length of the headless screws if necessary. Note: Make sure that the headless screws are lined up horizontally, in order to ensure that the fixture will be level.
- Page 3 5.Manual Override MODE (nighttime operation only; on at dusk,off at dawn) ● In 3, 6 or 0 mode, to shift to manual override mode, turn off the wall switch in 3 seconds and then turn it on again, the light will turn to high-level brightness at dusk, and turn off automatically at dawn. To return to the previous settings, turn off the wall switch in 3 seconds and then turn it on again.
- Page 4 T0251 A: 6"...