Year Setting; Month Setting; Date Setting - La Crosse Technology WS-8236U-AL Instruction Manual

Atomic clock with temperature, humidity and moon phase
Table of Contents

Advertisement

6.
Press and release the SET key to confirm the Time setting and continue to the Year setting.
Note:
The unit will still try to receive the signal every day despite it being manually set. When it does
receive the signal, it will change the manually set time into the received time. During reception
attempts the WWVB tower icon will flash. If reception has been unsuccessful, then the WWVB
tower icon will not appear but reception will still be attempted the following hour.
WWVB time reception takes place from 12:00 am through 6:00 am each day (attempts WWVB
reception every full hour within this time frame). When the time signal is received for example at
1:00 am, the atomic clock will not attempt to receive the WWVB signal for the remaining hours
until 6:00 am. Therefore, the next signal attempt will take place between 12:00 am and 6:00 am
the next day. The other times WWVB reception takes place, are upon setup and after manual time
set exiting mode. Reception is generally not possible during daylight hours due to the interference
of the sun.

YEAR SETTING

The year can be selected sequentially from 2003 to 2029 and will then start over again (default
setting 2004). None of the digits of the year will be visible on the lower LCD display however the
year must be correct as it affects the day of the week display.
1.
The year digits will start flashing in the lower LCD.
2.
Press and release the + key to select the desired year.
3.
Press and release the SET key to confirm the Year setting and continue to the Month
setting.

MONTH SETTING

1.
The month digits on LCD2 will start flashing.
2.
Press and release the + key to select the desired month.
3.
Press and release the SET key to confirm the Month setting and continue to the Date
setting.

DATE SETTING

1.
The digits for the date will start flashing in the lower LCD (Default setting 1).
2.
Press and release the + key to select the desired date.
3.
Press and release the SET key to confirm the Date setting and exit the manual setting
mode.
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ws-8236u

Table of Contents