Bosch Benchmark SHX88P Series Operating Instructions Manual page 12

en-us Getting Started
Time setting
W hen the appliance is switched on
T i m e s e t t i n g
for the first time, the time starts at
12:00 o'clock.
Set the time as follows:
Open the door.
1.
Switch on On/Off switch (.
2.
Press Info button 8 for
3.
3 seconds until the following text
is indicated on the display window
at the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
Keep pressing button > ` until
4.
the time setting is indicated on the
display window at the top @.
Make the setting with setting
5.
buttons + - X. If the selection
buttons + - X are held down,
the set values are changed in
10-minute increments.
Press and hold the Info button
6.
8 for 3 seconds.
The selected setting has now been
stored.
Settings
Switching on the appli-
ance for the first time
Language
Time format
Time setting
Water hardness
Rinse aid dispenser
12
Factory setting
American English
12h
12:00
°E0-8 Soft
Level 5
If the appliance was
Note:
disconnected from the power supply
for a prolonged period, the time
starts at 12:00 o'clock. Set the time.
Switching on the appliance
for the first time
When the dishwasher is switched on
for the first time, you are taken
directly to the settings for switching
on the appliance for the first time.
The following text is indicated on the
display window at the top @:
Scroll with < >
Set with + -
Leave with Setup 3 sec.
The required settings for switching on
the appliance for the first time are
listed in the table below.
Change the setting as follows:
Keep pressing button > ` until
1.
the required setting is displayed.
Make the selection with setting
2.
buttons + - X.
Press and hold the Info button
3.
8 for 3 seconds.
The selected setting has now been
stored.
Infotext
by pressing Info button
Language selection.
12h or 24h.
Set the current time.
Setting water hardness. When using Multitabs,
select the lowest setting.
Amount of rinse aid affects drying. When using
Multitabs, select setting 0.