Table of Contents
Advertisement
Available languages
Available languages
INTERCONNECTION
PROTECTION CIRCUIT
If the POWER LED ( 4 ) lits up, the device is in normal operation. If the PROTECT LED ( 3 ) lits up, the device is overheated. If this occurs, the
internal built-in protection circuit shuts down the device automatically. The device should work again properly after cooling down.
AUDIO SIGNAL CABLES
Connect the audio signal cables from the RCA outputs of the head unit to the RCA inputs on the device ( 1 ).
HIGH LEVEL INPUT
The HIGH LEVEL input ( 2 ) is suitable to connect the device input with speaker wires, if your head unit is not equipped with pre-amplifier
RCA outputs. Extend therefor every regarding speaker cable from your head unit with appropriate speaker cables from your car audio retailer
to the mounting location of the amplifier. Then connect the each matching loudspeaker cable with the cables of the included HIGH LEVEL
input jack.
NOTE: Never use the HIGH LEVEL input ( 2 ) and the RCA inputs ( 1 ) at the same time. This may damage the device seriously.
4
3
2
1
9
ENG
Advertisement
Table of Contents
