Advertisement
Blade installation
Install blade bracket with blade by 3 blade screws and
washers provided. Tighten screws securely. Repeat this
process for remaining blades. (Fig. 9)
Remove shipping stabilizers from motor assembly.
Install the blade assembly to motor using the preinstalled
screws. Tighten screws securely. Repeat this process for
remaining blade assemblies. (Fig. 9)
Note: Tighten blade bracket screws twice a year.
Switch housing installation and wiring
Loosen 2 and remove one set screws from the plate on
motor, keep screw. Attached top switch housing onto the
plate on motor, aligning its keyhole slots with the set screws
on the plate and twist clockwise until tight. Reinstall the
screw which is just removed and tighten all screws securely.
(Fig.10)
Remove tap from bottom of switch housing.
Thread lead wires from light fixture through central hole in
switch housing and then install switch housing onto light
fixture by turning clockwise till tight. Place lock washer and
hex nut provided over lead wire from light fixture and tighten
securely with the thread rod of light fixture. (Fig. 11)
Connect white wire from light fixture with white wire
from switch housing and then connect black wire from
light fixture with blue (or black) wire from switch
housing. (Fig. 11)
© 2014 Monte Carlo Fan Company
shipping stabilizers
Screws
Plate on motor
Set screws
Switch housing
Tap
7
Screws
Washers
Blade
Blades bracket
Fig. 9
Top switch housing
Fig. 10
Light fixture
Fig. 11
2/6/2014
Advertisement
