Philips Norelco BG7030 Manual page 5

Inspect shaving foil of the shaver head
before each use. Replace the foil element
when the foil is damaged (Fig. 10).
1 Press the shaver head on/off button to
turn on the product (Fig. 11).
2 Stretch your skin taut with your free hand
(Fig. 12), (Fig. 13). Gently press the shaver
head to skin and move it slowly and
smoothly against the direction of hair
growth (Fig. 14),.
- Do not press too hard. Too much
pressure can distort the foil and cause
skin irritation.
- Make sure the shaver head is always in
full contact with your skin.
- The shaver is bi-directional, which means
that you can shave by moving the
product up and down. Shave against the
direction of hair growth for optimal
performance.
3 Switch off and clean the product after
each use.
Cleaning
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as
gasoline or acetone to clean the product.
Never dry trimmer or shaving foil head with
a towel, brush or tissue, as this may cause
damage.
Cleaning the trimmer head
1 Turn off the product.
2 Remove the comb by pressing the length
selector (1) and sliding it upwards (2) (Fig.
15). Rinse the comb with water.
3 Open the cutting element by pressing
the cutting element upwards with your
thumb (Fig. 16).
4 Clean the hair chamber with the brush
and rinse it under the tap (Fig. 17).
5 Shake off excess water. Allow the
product to air dry completely.
- Never dry the twimmer head with a towel
or tissue, as this may cause damage.
6 Close the trimming unit. You will hear a
'click' (Fig. 18).
Reattach the trimming comb (1) and press
the length selector button to lock it in the
right position (2) (Fig. 19).
Cleaning the shaver
1 Turn off the product.
2 Pull the shaving foil unit out of the shaver
head (Fig. 20).
- Hold the shaving foil unit by the plastic
housing only.
3 Rinse the shaving foil unit with luke warm
running tap water. Shake off excess
water (Fig. 21).
4 Allow the shaving foil head to air dry
completely.
- Never dry trimmer or shaving foil head
with a towel, brush or tissue, as this may
cause damage.
5 Rinse the hair chamber under luke warm
running tap water to remove any residual
debris (Fig. 22).
6 Reattach the shaving foil unit by
snapping it back onto the shaver head.
You will hear a click (Fig. 23).
Storage
- Be sure the product is turned off.
Remove cord from outlet and the
product before storing it in a safe, dry
location where it will not be crushed,
banged, or subject to damage.
- Do not wrap cord around the product
when storing.
- Store cord in a safe location where it will
not be cut or damaged.
- Do not place or store the product where
it can fall or be pulled into a tub or sink,
water or other liquid while plugged in.
Accessories
Replacement parts may be purchased on
our website www.philips.com/store. For
maximum product performance, replace
shaving foil head once a year.
- Model BG2000 Philips Norelco
Replacement Shaving Foil Head.
Replacement
Replacing the shaving foil head
For maximum shaving performance, we
advise you to replace the shaving foil unit