Philips Norelco BG7030 Manual page 3

- Do not use the adapter in or near a
power outlet that contains an electric air
freshener to prevent damage to the
adapter.
- Do not charge, clean or plug in product
outdoors or operate where aerosol
(spray) products are being used or where
oxygen is being administered.
- Always check cutters, foil, cutting unit
and guards before using the product. Do
not use the product if cutters, cutting unit
or guards are damaged, as injury may
occur.
- Always attach power cord to product
first, then to outlet. Be certain plug is
inserted firmly into product up to mark
indicated on plug. To disconnect, turn
product off then remove power cord
from outlet.
- Keep the power cord dry at all times. Do
not handle with wet hands.
- Use only the cord provided to charge the
product.
- Never put the product in direct sunlight
or store at a temperature above 140°F
(60°C).
- This product is water-safe and can be
rinsed under running tap water or used in
shower. Do not submerge product in
water.
- To prevent possible damage to the cord,
do not wrap cord around the product.
- This product is for use on human hair
only. Do not use the product for any
other purpose.
- Always store the product, attachments
and power cord in a moisture-free area.
Make sure the cord is disconnected from
the product.
- Do not attempt to open the product to
remove or replace the built-in
rechargeable battery.
- Only use the power plug and other
accessories supplied with the product.
SAVE THESE
INSTRUCTIONS
IMPORTANT: The power plug contains a
transformer. Do not cut off the power plug
to replace it with another plug as this will
cause a hazardous condition.
Introduction
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benefit from the support that
Philips Norelco offers, register your product
at www.norelco.com/register.
General description (Fig. 1)
1 Shaver head
2 Shaver head on/off button
3 Battery status indicator
4 Trimmer head on/of button
5 Length selector
6 Trimming comb
7 Small plug inlet
8 Power plug
9 Small plug
10 Brush
Charging
Charging
Charging takes approx. 1 hour. Charge the
product before you use it for the first time
and when the display flashes orange o
indicate that the battery is almost empty.
- Charging, recharging or using the product
at temperatures below 40°F (4.5°C) or
higher than 95°F (35°C) adversely affects
the lifespan of the battery.
- If the product is subjected to a major
change in temperature, pressure or
humidity, let the product stand for 30
minutes before use.
1 Make sure the product is switched off.
2 Raise the inlet cover (1). Insert the small
plug into the product (2) (Fig. 3) and put
the power plug in any 120V-240 AC
outlet.
3 After charging, remove the power plug
from the wall outlet and pull the small
plug out of the product. Put the inlet
cover back in place.
Note: An adapter plug may be necessary for
cord usage in some foreign countries. Use
an attachment plug adapter of the proper
configuration for power outlet.