Advertisement
Step 1
Take the installation position map from the accessories bag and put it on the
surface of the ceiling or the wall according to the cable exit position. Drill three
holes according to the installation position map and then take three expansion
bolts from the accessories bag and put them into the holes you just drilled.
Step 2
Use the inner hex wrench to remove the three enclosure fastening screws and
then remove the dome enclosure.
Step 3
Adjust the pedestal position according to the cable exit move(ceiling/side). Pull
the cable through the cable side exit at the installation surface and the pedestal.
(Please skip this step if you are mounting on a ceiling). Line up the screw holes
at the bottom of the pedestal to the expansion bolts in the installation surface.
Put three self-tapping screws to expansion bolts and then secure firmly. Now the
pedestal is on installation surface.
Step 4
Adjust the camera module angle to a proper position and then fix the screws to
fasten.
Fastening Screw
Step 5
Use three enclosure fastening screws to secure the dome housing on the
pedestal.
Advertisement
