Advertisement
3.2
HD-CVI Plastic Housing
Step 1
Please take the installation position map from the accessories bag, and then
paste it on the ceiling or the wall according to your monitor area requirements.
Draw and then drill three holes in the installation surface and then insert three
expansion bolts in the holes. Secure these three bolts firmly.
Step 2
Turn counter clockwise to remove the decoration ring. Please drill a "cable exit
hole" in the surface according to the installation position map if you want to
draw out the cable from the top of the installation surface. You need to draw out
the cable from the cable channel side port of the pedestal if you want to draw
out the cable from the side port of the cable channel. Adjust the device instal-
lation pedestal to the proper position and then draw the cable through the ca-
ble exit. Line up the three screw holes in the installation position. Put the three
self-tapping screws in the three plastic expansion bolts firmly. Now the dome
camera is secure in the installation surface.
Ceiling or Wall
Expansion Bolt
Dome Camera Body
ST3 Self-tapping Screws
Decoration Ring
Advertisement
