Installation And Connection; The Control Panel; Rotary Selector; Accessories - Bosch HMT75M551I Instruction Manual

Table of Contents

Advertisement

Installation and connection

This appliance is intended for domestic use only.
This appliance is only intended to be fully fitted in a kitchen.
Please observe the special installation instructions.
The appliance can be fitted in a 60 cm wide wall cabinet (min.
30 cm deep and 85 cm off the floor).
The appliance is fitted with a plug and must only be connected
to a properly-installed earthed socket. The fuse protection must
be rated at 10 amperes (L or B circuit breakers). The mains

The control panel

Here, you will see an overview of the control panel. Depending
on the appliance model, there may be differences in the
particular details.

Rotary selector

The rotary selector is used to alter the default values and set
values.
The rotary selector is retractable. Press on the rotary selector to
lock it in or out.
6
voltage must correspond to the voltage specified on the rating
plate.
The socket must be installed and the power cable replaced by
a qualified electrician only. If the plug is no longer accessible
following installation, an all-pin disconnecting device must be
present on the installation side, with a contact gap of at least
3 mm.
Multiple plugs, plug bars and extension leads must not be
used. Overloading can result in a risk of fire.

Accessories

The turntable
How to fit the turntable:
Place the turntable ring a in the recess in the cooking
1.
compartment.
Let the turntable b slot in place in the drive c in the centre of
2.
the cooking compartment floor.

Advertisement

Table of Contents
loading

Table of Contents