Advertisement
2 Slide a suitable attachment onto the metal tube (
(
) and turn the ring to the right/anti-clockwise to lock it (
•
To remove the attachment, turn the ring to the left/clockwise to
unlock (
3 Connect the plug to a power supply socket.
4 Slide the on/off switch (
» The power-on indicator (
5 Place the appliance with the support (
surface.
6 Comb your hair and divide your hair into small sections that are not
wider than 2-4cm.
Create curls or ringlets (Fig.4)
1 Select small curling attachment (
ringlets.
2 Press the lever (
hair between the clip and barrel (
•
If you use the Slip-on spiral (
section of hair round the barrel following the spiral profile. (Fig.6)
3 Release the lever (
4 Hold the end of the cool tip (
the section of hair round the barrel from end to root.
5 Hold the barrel in the position for max. 10 seconds. Then unwind
the section of hair until you can open the clip again with the lever or
until you can remove the Slip-on spiral (
6 To style the rest of your hair, repeat steps 2 to 5.
Create free-flowing, modern curls (Fig.5)
1 Select conical curling attachment (
2 Press the lever (
hair between the clip and conical barrel (
3 Release the lever (
) and pull it off.
) to I to switch on the appliance.
) to open the clip (
) and slide the barrel (
) to open the clip (
) and slide the barrel to the hair tip.
) lights up.
) on a heat-resistant
) for styling tight curls and
) and place a section of
).
) to create ringlets, wind the
) and the handle (
) from your hair.
) for styling large curls.
) and place a section of
).
) of the handle
) to the hair tip.
). Then wind
).
Advertisement
