Summary of Contents for Seagate BarraCuda ST4000DM005
Page 1
SATA Product Manual Standard models ST4000DM005 100804656, Rev. B October 2016...
Page 2
Seagate, Seagate Technology and the Spiral logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. BarraCuda and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. All other trademarks or registered trade- marks are the property of their respective owners.
For information regarding online support and services, visit: http://www.seagate.com/contacts/ For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/data-recovery-services/ For Seagate OEM, Distribution partner and reseller portals, visit: http://www.seagate.com/partners/ Seagate BarraCuda Product Manual, Rev. B...
SATA ports are represented to host software as a Device 0 (master) and Device 1 (slave) accessed Note at the same set of host bus addresses. A host adapter that emulates a master/slave environment manages two sets of shadow registers. This is not a typical SATA environment. Seagate BarraCuda Product Manual, Rev. B...
12V ±10% Non-Operating (Ambient °C) –40° to 70° Operating ambient temperature (min °C) 0° † Operating temperature (drive case max °C) 60° 20°C per hour max (operating) Temperature gradient 30°C per hour max (non-operating) Seagate BarraCuda Product Manual, Rev. B...
Page 8
*** During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. † Seagate does not recommend operating at sustained case temperatures above 60°C. Operating at higher temperatures will reduce useful life of the product. Seagate BarraCuda Product Manual, Rev. B...
13 (typical) (in seconds) 15 (max) Ready to spindle stop 10 (typical) (in seconds) 11 (max) Time-to-ready may be longer than normal if the drive power is removed without going through normal OS powerdown procedures. Seagate BarraCuda Product Manual, Rev. B...
• Using 5-volt power, the drive is expected to operate with a maximum of 100 mV peak-to-peak square-wave injected noise at up to 10MHz. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current. Note Seagate BarraCuda Product Manual, Rev. B...
If the standby timer reaches zero before any drive activity is required, the drive makes a transition to Standby mode. In both Idle and Standby mode, the drive accepts all commands and returns to Active mode when disk access is necessary. Seagate BarraCuda Product Manual, Rev. B...
† Operating (Drive case max °C) 60° (140°F) † Seagate does not recommend operating at sustained case temperatures above 60°C. Operating at higher temperatures will reduce useful life of the product. 2.9.2 Temperature gradient Operating 20°C per hour (36°F per hour max), without condensation Non-operating 30°C per hour (54°F per hour max)
The maximum non-operating vibration levels that the drive may experience without incurring physical damage or degradation in performance when subsequently put into operation are specified below. 5Hz to 22Hz 3.0 Gs (Limited displacement) 22Hz to 350Hz 3.0 Gs 350Hz to 500Hz 3.0 Gs Seagate BarraCuda Product Manual, Rev. B...
Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses this threshold curve (originated in ISO 389-7) to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards.
(or part number) and country of purchase. The system will display the warranty information for the drive. 2.12.1 Storage Maximum storage periods are 180 days within original unopened Seagate shipping package or 60 days unpackaged within the defined non-operating limits (refer to environmental section in this manual). Storage can be extended to 1 year packaged or unpackaged under optimal environmental conditions (25°C, <40% relative humidity non-condensing, and...
As a subassembly, no Federal Communications Commission verification or certification of the device is required. Seagate has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disk drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules.
The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging.
For installations which require cables, users can connect the drive as illustrated in Figure 1 Figure 1 Attaching SATA cabling Each cable is keyed to ensure correct orientation. BarraCuda drives support latching SATA connectors. Seagate BarraCuda Product Manual, Rev. B...
• The screws should be inserted no more than 0.120 inch (3.05mm) into the bottom or side mounting holes. • Do not overtighten the mounting screws (maximum torque: 6 inch-lb). Figure 2 Mounting dimensions (4TB) Seagate BarraCuda Product Manual, Rev. B...
There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate back- plane configuration. • All used voltage pins (V ) must be terminated. Seagate BarraCuda Product Manual, Rev. B...
15 Shall be cleared to zero 4000 14 Shall be set to one 13:1 Reserved for the Trusted Computing Group 0 Trusted Computing feature set is supported Standard Standby timer, IORDY supported and may be disabled 2F00 Seagate BarraCuda Product Manual, Rev. B...
Page 25
0078 Recommended multiword DMA transfer cycle time per word (120 nsec) 0078 Minimum PIO cycle time without IORDY flow control (240 nsec) 0078 Minimum PIO cycle time with IORDY flow control (120 nsec) 0078 Seagate BarraCuda Product Manual, Rev. B...
Page 26
Total number of user-addressable LBA sectors available (see Section 2.2 for related 100–103 information). These words are required for drives that support the 48-bit ST4000DM005 = 7,814,037,168 addressing feature. Maximum value: 0000FFFFFFFFFFFFh. 104-105 ATA-reserved 0000 Physical sector size / logical sector size 6003 Seagate BarraCuda Product Manual, Rev. B...
Page 27
Integrity word xxA5 Advanced Power Management (APM) and Automatic Acoustic Note Management (AAM) features are not supported. See the bit descriptions below for words 63, 84, and 88 of the Identify Drive data. Note Seagate BarraCuda Product Manual, Rev. B...
Page 28
Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Seagate BarraCuda Product Manual, Rev. B...
Disable use of SATA features Enable read look-ahead (read cache) feature (default) Report full capacity available At power-on, or after a hardware or software reset, the Note default values of the features are as indicated above. Seagate BarraCuda Product Manual, Rev. B...
S.M.A.R.T. Enable Operations S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x04 (abort) is written to the Error register. Seagate BarraCuda Product Manual, Rev. B...
Page 31
ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100804656, Rev. B...