Manual Update Via A Usb Flash Drive (When The Update Via A Network Has Failed) - Sony SA-V90DW Help Manual

Help Guide
Home Audio System
MHC-V90DW

Manual update via a USB flash drive (when the update via a network has failed)

If [NETWORK ERROR] or [DOWNLOAD ERROR PUSH POWER] appears on the display, the software update has
failed. In this case, the home audio system will not respond to any operation and no function can be used, except the
(power) button operation. Follow the procedure below to check the home audio system's condition, then complete the
software update with an appropriate method.
Press the (power) button to turn off the home audio system, and then press it to turn on the home audio
1
system.
Wait for about three minutes (or until a network connection is established), then check the information on
2
the display.
When [UPDATE] lights up on the display: The update is not complete, though the home audio system can be
used normally. Turn the home audio system off again, then see the following to complete the software update using
a USB flash drive.
Update method 3: Manual update via a USB flash drive
When [NETWORK ERROR] or [DOWNLOAD ERROR PUSH POWER] appears on the display (the same
status as before turning the home audio system on again): The update has failed and the home audio system
cannot be used. Proceed to the next step to update using a USB flash drive.
The update procedure is different from "Update Method 3" and the following steps are required. In this case, the
update cannot be performed via a network.
If [NETWORK ERROR] or [DOWNLOAD ERROR PUSH POWER] appears on the display, follow the
3
procedure below to update.
1. Download the update file from the website below, then store it in a USB flash drive.
For customers in Latin America:
http://esupport.sony.com/LA
For customers in Europe and Russia:
http://www.sony.eu/support
For customers in other countries/regions:
http://www.sony-asia.com/section/support
Turn the home audio system off again.
2.
After turning off the home audio system, complete the following steps until turning on the power again within
three minutes.
Connect the USB flash drive to
3.
Turn the home audio system on.
4.
The information of the update's progress appears on the display and the update starts automatically.
[UPDATED] appears on the display and the home audio system enters standby mode or BLUETOOTH/Network
standby mode automatically when the updating is completed. When you turn on the home audio system for the
first time after an update, [UPDATED] appears on the display.
Hint
During an update, the information of the update's progress appears on the display, and [UPDATED] appears on the display when
the update is complete. Do not turn the home audio system off during the update.
(USB) port on the home audio system.
49