NEC UM280X User Manual page 58

• ALERT MAIL
ALERT MAIL (English
only)
SENDER'S ADDRESS
SMTP SERVER NAME
RECIPIENT'S ADDRESS
1,2,3
TEST MAIL
SAVE
• NETWORK SERVICE
PJLink PASSWORD
HTTP PASSWORD
AMX BEACON
*What is PJLink?
PJLink is a standardization of protocol used for controlling projectors of different manufacturers.This standard proto-
col is established by Japan Business Machine and Information System Industries Association (JBMIA) in 2005.
The projector supports all the commands of PJLink Class 1.
Setting of PJLink will not be affected even when [RESET] is done from the menu.
CRESTRON ROOMVIEW compatibility
The projector supports CRESTRON ROOMVIEW, allowing multiple devices connected in the network to be managed
and controlled from a computer or a controller.
For more information, visit http://www.crestron.com
<Setting Procedure>
Access to the HTTP server function, and make necessary settings for [CRESTRON] in [NETWORK SETTINGS].
This option will notify your computer of lamp replace time or error messages via e-mail
when using wireless or wired LAN.
Placing a checkmark will turn on the Alert Mail feature.
Clearing a checkmark will turn off the Alert Mail feature.
Sample of a message to be sent from the projector:
The lamp and filters are at the end of its usable life. Please replace the lamp and
filters.
Projector Name: NEC Projector
Lamp Hours Used: 100 [H]
Enter sender's address.
Enter the SMTP server name to be connected to the projector.
Enter your recipient's address. Up to three addresses can be entered.
Send a test mail to check whether your settings are correct or not
NOTE:
• If you execute a test, you may not receive an Alert mail. Should this happen, check if network
settings are correct.
• If you entered an incorrect address in a test, you may not receive an Alert mail. Should this
happen, check if the Recipient's Address is correct.
Click this button to reflect the above settings.
Set a password for PJLink*. A password must be 32 characters or less. Do not forget
your password. However, if you forget your password, consult with your dealer.
Set a password for HTTP server. A password must be 10 characters or less.
Turn on or off for detection from AMX Device Discovery when connecting to the network
supported by AMX's NetLinx control system.
TIP:
When using a device that supports AMX Device Discovery, all AMX NetLinx control system will rec-
ognize the device and download the appropriate Device Discovery Module from an AMX server.
Placing a checkmark will enable detecting the projector from AMX Device Discovery.
Clearing a checkmark will disable detecting the projector from AMX Device Discovery.
48
3. Convenient Features