Table of Contents
Advertisement
HT903WA-DP_DDEULL_ENG_2993
3/7/08
LED indicator of Wireless
Transmitter
LED color
BLUE
The main set is turned on, everything is connected
and transmitting.
RED
The wireless transmitter is in standby mode.
OFF (No display)
The DC cable is disconnected to the unit.
Initial setting an ID of
Transmitter
1 Connect the SOUND SIGNAL connector of
transmitter and the rear (right, left) speaker
terminals of main unit with the SOUND
SIGNAL cable:
2 Connect the DC IN connector of transmitter
and the transmitter connector of main unit with
the DC power cable.:
3 Connect power cord of each wireless
speakers to the wall power outlet.:
4 Turn the main unit ON.:
Blue LEDs of transmitter will flicker and Blue
LEDs of wireless speakers will flicker
in turn, then the Blue LEDs of both transmitter
and wireless speakers will stay on when the
wireless system works normally.
10:12 PM
Page 7
Setting an ID of Wireless
Transmitter
Operation
If an interference is occurred or you use a new wireless speaker, set the
ID.
1 Disconnect power cord of wireless speakers:
2 Press the ID. button for more than about
3 Connect power cord of wireless speakers.:
ON REMOTE
Be careful of the following
If there is a strong electromagnetic wave product nearby, interference may
occur. Put the unit (Wireless Speakers and main unit) away from there.(Ex:
Microwave oven)
If there is no audio signal for longer than 10 minutes, the Wireless Speakers
-
and Wireless Transmitter will be automatically switched to standby mode. In
power saving mode, both LEDs will turn red. LEDs will turn blue when there is
any audio signal back.
-
If you operate main unit then wireless speakers (rear speakers) sound within a
few seconds in standby mode.
-
POWER
3 seconds:
The blue LED indicator will quickly flicker.
ON Wireless Kit
-
ID.
-
7
Advertisement
Table of Contents
