Led Indicator Of Wireless Transmitter; Led Indicator Of Wireless Receiver; Setting An Id Of Wireless Transmitter - LG HT503SHW Owner's Manual

HT503SHW-DH_BESPLL_ENG_0373
LED indicator of Wireless
Transmitter
LED color
BLUE The main set is turned on, everything is connected
and transmitting.
RED The wireless transmitter is in standby mode.
OFF (No display) The DC cable is disconnected to the unit.
LED indicator of Wireless
Receiver
LED color
BLUE The Wireless Receiver is receiving a signal of
wireless transmitter.
RED The Wireless Receiver is in standby mode.
OFF (No display) The Wireless Receiver is turned off.
9/10/08 8:01 PM Page 7
Operation
Operation
Setting an ID of Wireless
Transmitter
When the unit is manufactured, the ID is already set. If an interference
occurs or you use a new Wireless Receiver, an ID is set again.
1 Connect the SOUND SIGNAL connector of
transmitter and the rear (right, left) speaker
terminals of main unit with the SOUND
SIGNAL cable.:
2 Connect the DC IN connector of transmitter
and the transmitter connector of main unit with
the DC power cable.:
3 Turn off the Wireless Receiver:
4 Press the ID. for more than 3 seconds:
The Blue LED indicator will quickly flicker
5 Turn on the Wireless Receiver:
Be careful of the following
If there is a strong electromagnetic wave product nearby, interference may
occur. Put the unit (Wireless Receiver and main unit) away from there.(Ex:
Microwave oven)
If there is no audio signal for longer than 10 minutes, the Wireless Receiver
and Wireless Transmitter will be automatically switched to standby mode. In
power saving mode, both LEDs will turn red. LEDs will turn blue when there is
any audio signal back.
If you operate main unit then wireless speakers (rear speakers) sound within a
few seconds in standby mode.
ON Wireless Kit
-
-
POWER Switch
ID.
POWER Switch
7