Philips 5102 Series User Manual page 58

Channel Number Conflicts
In some countries, different TV channels
(broadcasters) might have the same channel number.
While installing, the TV shows the list with channel
number conflicts. You need to select which TV
channel you want to install on a channel number with
multiple TV channels.
Note: Not support DVB-C.
DVB settings
Access DVB settings
1 - Press  , select Antenna/cable installation and
press OK.
2 - Enter your PIN code if necessary.
3 - Select Search for channels and press OK.
4 - Select Start now and press OK.
5 - Select Re-install channels, select Next and
press OK.
6 - Select the country where you are now and
press OK.
7 - Select Cable (DVB-C).
8 - Select Start to search channels, or
select Settings for DVB-C settings .
9 - Press  BACK to close the menu.
Network frequency mode
If you intend to use the fast Quick scan method
in Frequency scan to search for channels,
select Automatic. The TV will use 1 of the predefined
network frequencies (or HC - homing channel) as
used by most cable operator in your country.
If you received a specific network frequency value to
search for channels, select Manual.
Network frequency
With the Network frequency mode set to Manual,
you can enter the network frequency value received
from your cable operator here. To enter the value,
use the number keys.
Frequency scan
Select the method of searching for channels. You can
select the faster Quick scan method and use the
predefined settings used by most cable operator in
your country.
If this results in having no channels installed or if
some channels are missing, you can select the
extended Full scan method. This method will take
more time to search for and install channels.
Frequency step size
The TV searches for channels in steps of 8MHz.
If this results in having no channels installed or if
some channels are missing, you can search in smaller
steps of 1MHz. Using the 1MHz steps will take more
time to search for and install channels.
Digital channels
If you know your cable operator is not offering digital
channels, you can skip searching for digital channels.
Analogue channels
If you know your cable operator is not offering
analogue channels, you can skip searching for
analogue channels.
Reception quality
You can check the quality and signal strength of a
digital channel. If you have your own antenna, you
can reposition the antenna to try and improve the
reception.
To check the reception quality of a digital channel...
1 - Tune to the channel.
2 - Press  , select Antenna/Cable installation and
press OK. Enter your PIN code if necessary.
3 - Select Digital: reception test and press OK.
The digital frequency is shown for this channel. If the
reception is poor, you can reposition your antenna.
To check the signal quality of this frequency again,
select Search and press OK.
To enter a specific digital frequency yourself, use the
remote control digit keys. Alternatively, select the
frequency, position the arrows on a number
with  and  and change the number
with  and  . To check the frequency,
select Search and press OK.
Manual installation
Analogue TV channels can be manually installed,
channel by channel.
To install analogue channels manually...
1 - Press  , select Antenna/Cable installation and
press OK. Enter your PIN code if necessary.
2 - Select Analogue: Manual Installation and
press OK.
• System
To set up the TV system, select System.
58