Connection Of External Equipment (Some Models) - LG 29FG2CL Owner's Manual

Connection of external equipment (some models)

Combination
VHF/UHF Antennas
TV rear
300 ohm
Flat Wire
75 ohm
Antenna
Jack
300 to 75
ohm Adapter
300 to 75
ohm Adapter
Connecting an Outdoor Antenna
For the best reception, we recommend you use an
outdoor antenna.
Severely weathered antennas and antenna cables
can reduce the signal quality. Before connecting it,
necessarily inspect them. Any service center can
explain the various outdoor antennas available to
you.
300 Ohm Flat Wire
1. Connect the 300 ohm flat wire to screws on the
300 ohm to 75 ohm adapter.
2. Push the end of 300 ohm to 75 ohm adapter
into 75 ohm antenna jack.
75 Ohm Coaxial Cable
1. Connect the 75 ohm coaxial cable directly to the
75 ohm antenna jack.
Connecting a CATV Cable
If you subscribe to a CATV system, change the
antenna connection as described below.
75 ohm
Coaxial
1. Remove the 300 to 75 ohm adapter or the cable
Cable
from the set if attached.
2. Connect the CATV cable (75 ohm coaxial
75 ohm
cable) to the 75 ohm antenna jack.
CATV Cable
connection of additional equipment
You can connect additional equipment, such as
VCRs, camcorders etc. to your set.Here shown
may be somewhat different from your set.
These are an example drawing of typical jack
layout.
1. IN 1 JACKS : Connect external equipment
outputs (VCR, LASER DISC, CAMCORDER) to
300 ohm Flat Wire
these inputs. Press the TV/VIDEO button to
select
2. IN 2 JACKS : Connect external equipment
outputs (VCR, LASER DISC, CAMCORDER) to
these inputs. Press the TV/VIDEO button to
select
3. IN 3 JACKS : Connect external equipment
outputs (VCR, LASER DISC, CAMCORDER) to
these inputs. Press the TV/VIDEO button to
select
4. OUT JACKS: Connect external equipment
inputs (VCR, Audio amplifier) to these outputs
for recording or monitering the selected
program.
Note:This TV is programmed to remember which
mode it was last set to, even if you turn the TV off.
4
1
15
1.
300 to 75 ohm
Adapter
75 ohm
Antenna Jack
75 ohm CATV Cable
2.
from cable TV source
AV1 .
.
AV2
AV3 .
OUT
VIDEO (L/MONO) AUDIO (R)
2
IN1
3
3
COMPONENT
P P
Y
B R
DVD IN(480i)
VIDEO (L/MONO) AUDIO (R)
IN2
AV IN 3