Changing The Door Opening Direction - Smeg FD260P Instructions For Use Manual

Changing the door opening direction

Appliance: HZZS3067/ HZZS3067F
Tools required: ring spanner (box-end wrench) No. 8, screwdriver, torx25, fl athead
screwdriver
1. Use a fl athead screwdriver to remove the hole plugs/covers A and B1.
2. Unscrew and remove – one by one, in the specifi ed order from top to bottom – the hinges (C, D,
and E1) and the door (F, G). Make sure the door is not damaged.
3. Move the hole plugs / covers (H) to the opposite side.
4. Attach the lower hinge (E2, supplied in a bag) to the opposite side of the housing and add the
washer (I).
5. Upper door (F): Move the upper hinge (C) with the bearing (J) to the opposite side. Remove the
door stopper with the hinge (K1) and attach a symmetrical door stopper (K2, supplied in a bag)
to the opposite side.
6. Lower door (G): move the hinges (L) and the cover (M) to the opposite side.
7. Install / attach, from bottom up, the hinges (D, C) and doors (G, F). Do not forget to install the
washers in the same way they were installed before disassembling (I).
8. Install the covers A and B2 (cover B2 from the supplied bag).
9. Replacing the handle: remove the hole plugs/covers, unscrew the screws and attach the
handle to the opposite side. Insert the plugs into the holes on the opposite side.
Save the elements B1, E1, and K1 in case you need them to change the door opening direction
again at a later time.
8