Battery Pack Operation; Charger Operation - sunjoe WA24C-LT-RM Operator's Manual

Battery Pack Operation

The equipment is powered by a lithium-ion battery. The battery
pack is completely sealed and maintenance free.
Battery Charge Level Indicator
The battery pack is equipped with a push button for checking
the charge level. Simply press the push button to read off the
battery charge level from the LEDs of the battery indicator:
• All 3 level monitoring LEDs are lit: Battery charge level
is high.
• 2 level monitoring LEDs are lit: Battery charge level is
decreasing. Stop work as soon as possible.
• 1 level monitoring LED is lit: Battery is flat. Stop work
IMMEDIATELY and charge the battery. Otherwise the
battery's service life will be greatly shortened.
Lights Light Indicators
Charge level button
The battery is at 30% capacity
and requires charging
The battery is at 60% capacity
and requires charging soon
The battery is at full capacity
NOTE: If the charge level button does not appear to be
working, insert the charger and charge as needed.
NOTE: Immediately after using the battery pack, the charge
level button may display a lower charge than it will if checked
a few minutes later. The battery cells "recover" some of their
charge after resting.

Charger Operation

m
WARNING!
Charge only Ecosharp
lithium-iON battery packs with compatible iCHRG24-AC
lithium-iON battery charger. Other types of batteries may
cause personal injury and damage.
To reduce the risk of electric shock, do not allow water to flow
into the charger's AC/DC plug.
When to Charge the Ecosharp
iBAT24-LT Lithium-iON Battery
®
NOTE: The Ecosharp LITE iBAT24-LT lithium-iON battery
packs do not develop a "memory" when charged after only a
partial discharge. Therefore, it is not necessary to run down the
battery pack before inserting the charger plug.
• Use the battery indicator lights to determine when to charge
• You can "top-off" your battery pack's charge before starting
Charging the Battery
1. Open the battery compartment cover, and push the push
2. Check that the mains voltage is the same as that marked
®
LITE iBAT24-LT
®
LITE
3. The battery will take approximately 100 minutes to charge.
10
®
your Ecosharp LITE iBAT24-LT lithium-iON battery pack.
a big job or after a long day of use.
lock button on the battery to pull the battery out from the
battery compartment (Fig. 3).
Fig. 3
Push lock button
Battery
compartment cover
on the rating plate of the battery charger. Then, plug the
charger adapter into an appropriate AC power outlet.
Connect the charger plug into the charge socket of the
battery to start charging (Fig. 4).
Fig. 4
The battery indicator LEDs will twinkle and illuminate one
by one during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
Battery
Battery
indicators