Troubleshooting - JVC XV-N380BA Instructions Manual

Troubleshooting

Symptom
• The power cord is disconnected.
No power.
• No disc is inserted.
The power is on, but
the DVD player does
not work.
No picture. • The TV is not set to receive DVD
• The video cable is not connected
• The [TV Output Select] options is set
• The equipment connected with the
No sound.
• The power of the equipment
• The AUDIO options are set to the
• An unplayable disc is inserted.
The DVD player does
not start playback.
• The remote control is not pointed at
The remote control
does not work properly.
• The remote control is too far from the
• The current remote control code does
Possible Cause
signal output.
securely.
to the wrong position on the setup
menu for the S-VIDEO or
COMPONENT VIDEO connection,
audio cable is not set to receive DVD
signal output.
connected with the audio cable is
turned off.
wrong position.
the remote sensor on the DVD player.
DVD player.
not match the unit.
Correction
• Plug the power cord into the wall outlet
securely.
• Insert a disc. (Check the disc indicator
in the display window is lit.)
• Select the appropriate video input
mode on the TV.
• Connect the video cable securely.
• Set the [TV Output Select] option to
the correct position on the setup menu
regarding to the current video
connection. (See page 12.)
• Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD player.
• Turn on the equipment connected with
the audio cable.
• Set the AUDIO option to the correct
position, then turn on the DVD player
again by pressing STANDBY/ON.
• Insert a playable disc. (Check the disc
type and regional code.)
• Point the remote control at the remote
sensor of the DVD player.
• Operate the remote control closer to
the DVD player.
• Identify the remote control code with
the code of unit. (See page 19).
21